Fakopp Pulling Test
Tree Inspection
    At present, the most accepted method for evaluating the safety and stability of trees is the pulling test. It involves applying a bending load on the trunk via a cable attached to the tree. The method can be used either to assess the uprooting stability of the tree, or to establish the risk of trunk breakage.

    There are overlaps among the equipments needed for DynaRoot and Pulling test. If you order both of them at the same time you can ask for a switchable Dual Elastometer Unit and High Precision Inclination and Deformation Recorders.
  • consult
Details Solution Applications Downloads Order

Make sure you follow all the safety instructions throughout the test!

Attach the cable to the trunk in the crown of the tree, as high as possible.
Choose an anchor point in the appropriate direction, about 10 to 15 m from the tree.
Set up the winch and ropes according to the guide.
Install the load cell.
Install the inclinometer sensors.
Install the extensiometer sensors.
Connect all sensors to the central unit.
Switch on the units, and press “Tara” on the load cell.
Start the Pulling Test software.
Start measurement by loading the cable slowly and evenly using the winch.
 
Solution
Applications
Downloads
Order
Related Recommendations
WeChat
Micro-blog
Total Solution Provider for Advanced Civil Engineering Testing Instruments
  • 400-700-9998
  • Service Time : Monday to Sunday, 9:00-18:00
  • E-mail : marketing@epc.com.hk
Copyright © 2008~2015 Earth Products China Ltd. all rights reserved. 粤ICP备12064742号 Domestic headquarters address:West Tower 2301, Fortune Plaza, No. 116, sports east road, Tianhe District, Guangzhou
Hong Kong Headquarter Address:12/F, Asia Trade Centre, 79 Lei Muk Road, Kwai Chung, Hong Kong
Home
Products
Solutions
About Us